From markm6339–(at)–ol.com Fri Nov 20 10:31:09 CST 1998
Article: 32018 of rec.music.makers.builders
From: “Mark Middleton”
Subject: Re: 3 corner file trick on the fret ends
Date: 20 Nov 1998 14:39:45 GMT
Organization: Stoner Associates, Inc.
X-Newsreader: Microsoft Internet News 4.70.1161
Xref: geraldo.cc.utexas.edu rec.music.makers.builders:32018
dunwell.guita–(at)–orje.SEE-MY-ORGANIZATION wrote in article
> In article <19981119161632.09498.0000020--(at)--g02.aol.com>,
> (MMGGUITARS) writes:
> >I use the 3 corner file trick and get the fretboard marks too! I even
> >masking tape on the ground surfaces.
> “You’re Pushin’ too hard, your pushin’ too hard…..”
> Those little stainless guards that LMI/StewMac sells are nice too, but
> make sure you put some tape on the bottom or *they* will make scratches
Another little tip: “Those little stainless steel guards” for your frets
are available from most office or art supply stores at a fraction of the
Stew-Mac cost. They are called erasing shields and are found in the
drafting supplies department and come in a variety of shapes and sizes.
They are used in the drafting and art trade to shield parts of a drawing
>from the ravages of an electric eraser.